Hot Rod Builds a 1000+ horsepower capable Coyote engine with MPR Engines. They chose to use JE electroless nickel coated pistons, Tuff Skirt, DLC pins, and Pro Seal gaskets. Check it out here!
READ MORELatest Posts
On this Inside the Engine, we take a look into Fredric Aasbo's 1000hp 4-cylinder that's also in his new iM race car for 2017! Built in SoCal by Papadakis Racing.
READ MOREMay 2, 2017 | By Mark Gearhart
Turnology built an S54 BMW M3 engine featuring JE pistons and Pro Seal head gaskets, check out the story here!
READ MOREApril 26, 2017 | By Mark Gearhart
A couple of interesting talking points were revealed about the AMC 390 V8 that engine builders should note if they tackle such a vintage platform. Most important, the oil system leaves much to be desired, so Rhyne Competition Engines out of Gary,..
READ MOREMarch 9, 2017 | By Mike Magda
Boats sustain high RPM loads for extended periods of time and require additional considerations over a car's engine. We explain some of the differences on this 900hp BBC build.
READ MOREFebruary 17, 2017 | By Eric LaBore
